All

Ohlins Airspring video "why 95% of riders use it wrong" - figured i'd post here to hear your findings

Is that a tech rumor? Found it pretty sick ( Mighty Argo gondola in Idaho Springs).

I'm really excited for the XTR embargo to be over so I can get more miles in on the new not-a-clutch clutch mechanism on my primary bike. Very curious how it will affect suspension feel to have spring force instead of friction controlling the cage on my long travel bike with relatively high anti-squat.

103.99 bcd

DUB only.

change 104BCD to a new proprietary chainring?

Put a SRAM logo on it and charge more? 🙃

This is funny it doesn’t deserve downvotes

heres a link to many manufacturers who will sell you one Category:Bus manufacturers - Wikipedia

I wouldn't tell people I'd won the lottery, but there'd be signs.

It’s one of the few forks I didn’t feel like I needed the spacer out. The only gripe I have with mine, is the negative spacer can actually float up on compression and then tap the bottom on rebound. You can hear it when bouncing around in a parking lot. I spoke with Öhlins USA about it, and that was what we determined the noise to be. You could probably put a small o-ring in there to act as a bumper but I haven’t bothered to try. Some silicone grease helped hold it in place for a while and kept...

I did nothing with it, I left well enough alone and have been thoroughly enjoying my 38 in stock form since I got it. I think the air spring design and base tune is one of the things that really sets this fork apart. For me, as an aging 200-lbs hack, I see no need to fiddle with the negative air volume at all - this fork is one of the most dialed I have ever ridden, it offers a great mix of support and comfort that just gets better the harder you push it. If I ride flatter terrain...

This video is definitely a bit of a storm in a teacup, it has to be said. First of all, there is no air exchange between the main positive air spring and the ramp up chamber (they are separated by a piston), so even if you were to get things completely wrong, you could just pump up the ramp up chamber again and be back to square one. If you run the ramp up chamber super low you just end up with a very linear fork - similar to running no tokens in a classic set-up. Second, there is typically...

I think safely does marginally decrease with the lowest model, but it’s not lower or less safe than the current Speedframe (and other helmets with single EPS / standard MIPS design). Thankfully haven’t heard any noise from the different layers interacting.