All

Good eye. Unfortunately the original resolution shots uploaded to PB aren't particularly large, but this is probably the best look.

Not sure if anyone else spotted it, but it appears that Vali Höll has got a set of Sram’s new Maven levers (now in silver, and widely believed to be a mineral oil brake), with the red prototype callipers, which, as far as I can remember, have only previously been tested with Sram’s current levers which use DOT fluid. Not sure if this means anything but it definitely piqued my interest. It’s also worth pointing out that Sram has had 6 months to use the ‘Maven’ trademark which started on the 5th of September last year, which will be up...

Right up there with the Enduro.

Oneup has to be one of the only brands in MTB who actually give riders what they want Including the price point. Decent quality, well thought out without complication products The only thing extra thing i want from a dropper is a decent way to access the seat rail clamp bolts.

Back to rumors saw what I believed is the new sram brake? I know it’s been around a bit but here’s a shot again If they are as power as TRP and feel like a code leaver I’m sold!

I like this lower fork mount I spotted on MountainBikeAction IG

May I request to snuff this fire? We have already discussed this and quite frankly, its almost as bad as some of the ebike motor comparison debates. Hate to be that guy but…

Looks like Fox has published part info for their 2024 forks. New Grip2 valving. Upgrade kit will be available. https://www.ridefox.com/fox17/help.php?m=bike&listall=partlist

Here’s my 3 versions. Farthest is 1st.

I take mount photo tomorrow. But when I did my final print, I used 80% fill then just drill and tapped it like the shock bolt. When mounting to shock, I’ll put double sided tape and a zip tie. Feels really solid and clean. Heres a photo of my first try then I shaved it down.

Finally had some time to make a 3D printed top mount. I also drilled and tapped the lower shock bolt. Now I can add or remove the rear sensor without touching the shock.

I have received it and set it up last night. Initial run will be either today or tomorrow. Should have time to get real data on Sunday as well. Into the rabbit hole...

Cool and fresh? You’d probably blow a load if they added a Girvin flexstem to this ridiculousness.

Is it really a rumour if you post your own bullshit?

Anyone have cool or custom 3D printed mounts they want to share? I’ve seen some really cool shock mounts by some race team mechanics.

K. That’s enough of USD fork talk here.