Lives in:
3777, VIC, AU
Member Since:
2/7/2024
Recent Activity
All
Zander Wills Added a reply to DIY mtb telemetry system
8/18/2024 6:32pm I just used a 3.7V~4.2V 18650 lithium battery for my project as it was cost effective and then I brought a charging module for it so it can be recharged. Yes I do get 3 files every time and I preferred it that way just for me then i can copy them each easier into a sheet compared to having...
More »
Zander Wills Added a reply to DIY mtb telemetry system
7/17/2024 5:25pm Hi all, Thank you for the advice and I am back a few months later with my school project telemetry system witch I got up and running and took it up to my local dh track the other weekend to test it out and all went well with no issues found yet. Goggle sheets was used to get the graphs...
Zander Wills Added a reply to DIY mtb telemetry system
2/8/2024 6:47pm Thank you for the feedback. Kind of dumb question but I was wondering would i need to have 2 raspberry pi pico one for each of the sensors or would I be able to run both sensors into the same pico? and I have been doing quite a bit of research and there isn't much information that I have found...
TheSuspensionLabNZ Liked a reply to forum topic DIY mtb telemetry system
2/8/2024 6:41pm
Sounds like a cool project! Theres a few layers to deal with between whats happening at the wheel and viewing the data. #1 reading the electrical signal from your sensor - this could be digital (ones and zeroes representing sensor value) or analogue (a voltage that changes depending on the state of the sensor). Each has pros and cons - sounds like your sensors are analogue so one of the parts of your circuit will be an anlogue-digital converter or ADC #2 Turning that signal in to a meaningful value and recording it to onboard storage. Ideally this is done...
This forum topic has 133 replies.
Zander Wills Added a reply to DIY mtb telemetry system
2/7/2024 5:49pm Hi everyone I have found this thread as I am thinking about making a telemetry system for my downhill bike for my year 12 project and I have read through this thread and wanting to use a (Linear position travel sensor with eye rodT-PTS12) for my front and rear sensors I was just wondering what people recommend for like a...