4li2k73z   Share your Vital activity on Facebook (More info)
close
Added a new video Mountain Creek Spring Classic 2013 5/21/2013 11:20 AM
C138x104

The Mountain Creek Spring Classic, and Eastern States Cup #1 / Pro GRT #4 in Vernon, NJ

This video has 2 comments

Liked a bike check Santa Cruz Blur Ltc 650b 4/19/2013 5:55 PM
C138_img_8892
Added a comment to Mptango's bike check 4/19/2013 5:54 PM
C138_img_8892

Look at this sick whip!

This setup has 1 comment.

Added a comment about photo Art Babcock - down, but not out! 3/19/2013 1:00 PM
C138_19_art_babcock_injury

Did your shoe stay on at least?!

This photo has 3 comments.

Added a comment about photo Geoffry Ayr, AKA "The Postman" rolling in. 3/19/2013 12:57 PM
C138_8_postman_rolling_in

Ayr, going postal! Braap!

This photo has 6 comments.

Added a comment about photo Jacqueline Harmony Pro Women's Winner Reaper Madness Pro GRT 3/19/2013 12:55 PM
C138_3_jacqueline_harmony_pro_womens_winner

WTG Jackie, you killed it!

This photo has 1 comment.

Added a comment about product review Tested: Manitou Dorado Expert - A Worthy Contender 3/4/2013 11:33 AM
C50_mdelorme_mtncreekprogrt_2012_3267

Special care and attention is needed when installing the dorado axle, you can't just push it in, tighten the end bolt then the pinch bolts. Doing this leaves a 2-3mm gap between the fork leg and the hub cone, this causes the seal to ovalize, therefore causing premature seal failure. To properly install, you must push the axle in, let the end of the axle stick out about 1mm, or just enough to feel a lip, dont make it flush, then tighten those pinch bolts, then you can tighten the end bolt, then finally the other pinch bolts. This will let the fork dropout seat tightly with the hub cone, and have proper stanchion alignment for the seal. Then your seals will last easily a whole season or more. Front wheel Installation is like an MX fork. If done improperly, you will see the axle between the hub cone and the fork dropout, thats bad.

This product_review has 11 comments.

Added reply in a thread 2012 Kona Operator - Med 1/15/2013 9:06 AM

Great deal for someone just getting into the sport, or looking for a new ride.

Added a comment about photo Chris Calleros and David Meredith with the One Ghost Long Bow 1/14/2013 12:54 PM
C138_17race

Ear wax is good for that stache.

This photo has 2 comments.

Added a comment about press release 2013 USA Pro Gravity Tour Schedule Released 12/22/2012 2:00 PM
C50_mdelorme_mtncreekprogrt_2012_3267

Looks good, but it should have had all 4 east coast races together, not 2 out east, 2 out west, 2 out east again, tough on a lot of racers that cant afford that much back and forth.

This press release has 29 comments.

Added a comment about photo e.thirteen's new TRSr Cranks 11/14/2012 10:03 AM
C138_e13_1

Perfect!

This photo has 4 comments.

Added a comment about photo First Look at e.thirteen's Carbon LG1r Chainguide 11/14/2012 10:03 AM
C138_e13_6

Yes, just yes!

This photo has 8 comments.

Added a comment to One Ghost's bike check 11/5/2012 3:20 PM
C138_bars_top_qtr_crpoppred

Sick

This setup has 3 comments.

Added a comment about photo Jason Scheiding 10/22/2012 7:43 PM
C138_bib232

They spelled my name wrong.
Thanks for the photo Dave!

This photo has 3 comments.

Added a new video Gravity East Series finals - 7 Springs ,PA - 2012 10/2/2012 9:54 PM
C138x104

The final stop of the Gravity East series for 2012 at 7 Springs resort in Seven Springs, PA.

This video has no comments yet

Added a comment about photo John Parker at the KOM Enduro 10/1/2012 8:45 AM
C138_komenduromtncrk_mdelorme_2012_9_29_0804

Yeah John!

This photo has 1 comment.

Added a comment about photo Red Bull Rampage Pro Bikes: Brendan Fairclough's ??? 9/27/2012 7:13 AM
C138_brendog

He should just ride rampage on that DJ!

This photo has 2 comments.

Added a comment about photo Red Bull Rampage Pro Bikes: Cam McCaul's Trek Session 9.9 9/27/2012 7:10 AM
C138_mccaul

Carbon at rampage! Look like the rear end is still aluminum though.

This photo has 13 comments.

Updated bike check JasonScheiding's Setup 9/15/2012 8:22 PM