Accessibility Widget: On | Off
PRESS RELEASE

Hand Polished to Perfection and Ready to Tune - Manitou Introduces the Sterling Edition Mezzer Pro 2

A very limited production run means that riders will have to move quickly if they want this fork.

Photo

Introducing the Sterling Edition of the Manitou Mezzer Pro. Utilizing the same 37mm chassis and internal tech as our existing Mezzer Pro, each Sterling Edition fork receives an extra level of detail and care before leaving the factory floor. To create an ultra-smooth and crisp paint finish, each lower leg and crown assembly are polished by hand in preparation of the paint booth. Combining this brilliant finish with the already brilliantly tunable Mezzer platform creates the crown jewel of suspension forks for anyone looking to upgrade their front end.

Photo
Photo

As with all Mezzer Pros, riders will enjoy the ultimate tunability of their air spring thanks to the pairing of our Dorado Air system and IRT (Infinite Rate Tune). Dorado Air is derived from, you guessed it, our legendary Dorado inverted DH fork. Using a unique balancing valve at the piston, the positive and negative air springs are equalized during the air fill process. This design provides a smooth and consistent spring rate without any flat or dead spots that can be caused by a balance groove. It also allows users to change the travel easily with the included travel spacers rather than purchasing expensive air springs. 

Acting as a secondary positive air chamber the IRT provides complete control over the mid-late stroke of the fork. This allows riders to tune their initial stroke separate from their mid-late allowing a butter-smooth initial feel without sacrificing mid-stroke support. Being a compressible air chamber, rather than solid volume spacers, as you approach bottom out you are met with a feeling that is smooth and consistent rather than hash and abrupt.

Photo

The damping is taken care of through our fully sealed MC² cartridge damper. Adjustments include external high and low-speed compression damping as well as low-speed rebound. We have also included a factory set HBO (hydraulic bottom out) to give riders an added level of control when things get gnarly. 

Bleeder screws are also located on the back of the lower legs allowing riders to bleed air while on the trail using a 2.5mm hex key. These bleeder screws double as an oil injection port to give your seals a small blast of semi-bath oil in-between regular service intervals to keep things as smooth as possible at all times.

Photo
Photo

The Sterling Edition of the Mezzer Pro will be limited to 250 units globally and only available through our trusted dealers and your local bike shops. Make sure you contact your local dealer and reserve one today!

Click here for more info.

Create New Tag
2 comments
Show More Comment(s) / Leave a Comment