Accessibility Widget: On | Off
Added bike check Monochrome Yeti SB150 1/7/2021 11:17 PM
Monochrome Yeti SB150
Added a comment to Wafflesnatcher's bike check 8/7/2020 1:57 PM
Oil Slick Yeti SB150

I did it by having visible lines haha. You can see one at the TT/ST joint, and on the DT, just back from the headtube. Big thing with wrapping bikes is get the best vinyl possible, it makes a huge difference (I use only 3M or Avery Dennison) So it can get around the complex corners. If you run two big side panels and wrap towards the centre, you end up with clean on the sides, and a single seam down the middle. Also, non-printed vinyl is very thin, so as long as it's not a pattern that will mis-match, seams are pretty hard to see.

This setup has 21 comments.

Added a comment to Wafflesnatcher's bike check 2/11/2019 1:35 AM
Oil Slick Yeti SB150

Did it myself, with a mate helping. Asked a few car wrap places and they declined it, and fair enough, because it was pretty rough getting round some of the curves. Decals are seperate to the wrap, printed separately and put on top, then the Invisiframe on top of that.

This setup has 21 comments.

Added a comment to Wafflesnatcher's bike check 2/10/2019 11:40 PM
Oil Slick Yeti SB150

Funnily enough AXS was announced about 5 hours after I finished the decals haha, but I think it'd be pushing it.

0 0 0

This setup has 21 comments.

Added bike check Oil Slick Yeti SB150 2/10/2019 10:52 AM
Oil Slick Yeti SB150